|
CONNECTING AND USING DIGITAL MULTIMETER
WITH PC
|
Multimeter
type PeakTech 450 is connected with PC using serial RS232
communication channel and driver on PC side
|
|
CONNECTING AND USING 16
CHANNELS
LOGIC ANALYZER WITH PC AND LABVIEW
|
Hewlett Packard type HP 54620 C Logic analyzer with
serial RS232C and GPIB communication is connected to PC , using GPIB controller on
PC side ( NI - USB/GPIB adapter ). Proprietary
driver as well as VIs for integration with
LabView used for signal visualisation and processing.
|
|
CONNECTING AND USING 98 CHANNELS LOGIC
ANALYZER WITH PC AND LABVIEW
|
Hewlett
Packard type HP 1671E Logic analyzer with serial RS232C and GPIB
communication is connected to PC , using GPIB controller on
PC side ( NI - USB/GPIB adapter ). Proprietary
driver as well as VIs for integration with
LabView used for signal visualisation and processing.
|
|
CONNECTING AND USING SPECTRAL ANALYZER WITH PC AND LABVIEW
|
Hewlett Packard type HP 8562E spectral analyzer with serial RS232C
and GPIB communication is connected to PC ,using GPIB controller on
PC side ( NI - USB/GPIB adapter ). Proprietary
driver as well as VIs for integration with
LabView used for signal visualisation and processing.
|
|
CONNECTING AND USING 2
CHANNELS
OSCILLOSCOPE WITH PC AND LABVIEW
|
Hewlett Packard type HP 54645A two channels osciloscop with
serial RS232C and GPIB communication is connected to PC , using GPIB controller on
PC side ( NI - USB/GPIB adapter ). Proprietary
driver as well as VIs for integration with
LabView used for signal visualisation and processing.
|
|
FFT SIGNAL SPECTRUM ANALYSIS WITH HP 54600 OSCILLOSCOPES
|
HP 54645A 2 channels oscilloscope with installed computing and
measurement storage module HP 54657A used as FFT analyzer. Test signals and
waveforms for analysis generated using HP 54654 training kit.
|
|
CONFIGURATION
AND CONNECTION OF I/O DAQ MODULES WITH PC TO CREATE LABVIEW VIRTUAL
INSTRUMENTS
|
IoTech DAQ modules DAQBOARD/200A ,DBK15, DBK 20, DBK 10 with
drivers for LabView software and LabView installed on PC
|
|
DAQBOARD/200A
based Data acquisition system with PC and Labview in acquistion
of data from asynchronous machine test stand
|
IoTech DAQ modules DAQBOARD/200A ,DBK15, DBK 20, DBK 10 with
drivers for LabView software and LabView installed on PC
acquiring and processing data from asynchronous motor with break test stand
|
|
CREATING TEST SETUP INTEGRATION
OF MATLAB-SIMULINK MODELS WITH LABVIEW USING NI-SIT SOFTWARE
|
NI - Simulation interface toolkit
( SIT ) is used to interface and enable signal excahnge between
MATLAB-SIMULINK models and LABVIEW front panel interface for signal
visualisation and processing, either on the same and distributed PC
machines.
|
. 
